Contact Us
TEL: +86-752-7803358
FAX: +86-752-5872218
E-mail: sales@magtop.com
Address: Building A, Pingnan Geumgok Power Ind. Park, Zhongkai  High-tech Zone, Huizhou, Guangdong, China.
Home > Exhibitions > Content
The common-mode inductor should meet the following requirements when making
Jan 04, 2018

(1) The wires around the core of the coil are insulated from each other to ensure that the windings of the coil are not short-circuited in the turn of the instantaneous over-voltage effect;

(2) When the coil flows through the instantaneous large current, the core does not appear saturation;

(3) The core of the coil should be insulated from the coil to prevent the breakdown between the two under instantaneous over-voltage;

(4) Coil should be made as far as possible around the single layer, so as to reduce the parasitic capacitance of the coil, enhance the coil on the instantaneous overvoltage withstand capacity.

Usually, at the same time, pay attention to select the desired filter band, the greater the common-mode impedance is better, so we in the selection of common-mode inductors need to look at the device data, mainly based on impedance frequency curve selection. In addition, pay attention to the influence of the differential mode impedance on the signal, focusing on the differential mode impedance, pay special attention to the high speed port.


Previous: Loop inductance

Next: The overall advantage of the magnetic ring type: